Truck tire noise: Sounds of (almost) silence

Tire noise: Sounds of (almost) silence

If you’ve been an observant motorist for 20 years or more, you may remember when truck tires were noisy. Much has changed in recent years and one benefit of modern tire technology is that linehaul radials are now almost universally quiet—to the point that the noise generated by rolling down the interstate under load is benign with rare exceptions. Other trends, however, may change the role that tire noise plays in the total noise generation of future trucks.

Truck noise has traditionally been evaluated by two different test procedures; both using actual decibel measurements, typically outdoors, against a relatively quiet background in calm weather conditions. The first procedure, referred to as “power-on pass-by,” runs at steady state highway speed, emphasizing exhaust, cooling fan, turbo whine and related noise generated by the working drivetrain under a torque load on level ground. The second procedure, referred to as a “coast-by,” measured primarily tire and aero noise as the truck passed by microphones in a coast (neutral or clutch in) mode.

Sound levels generated by nearly all of the primary truck noise generating components have been reduced over the last two decades. Turbochargers and other post-exhaust treatment devices, along with cooling fan technology, have generally been credited with the biggest share of this reduction. Aero advancements have made significant contributions to enhanced fuel efficiency, while at the same time, reducing overall noise levels. Recently, cab designs, insulation, seating advancements and damping suspensions have added to noise reduction, as perceived by drivers.

Tire noise has benefitted greatly from the use of CAD programs that help predict sound levels at various load, speed conditions and on different road surfaces. In fact, some modern radials generate less noise than that same tire would if it had a completely smooth tread.

Therefore, tire designers must consider the type and aging characteristics of pavement surfaces for noise generation, similar to considerations for traction, when new tread patterns and rubber compounds are being evaluated. Some general guidelines are that drive tire patterns tend to be louder than straight rib designs common on steer and trail axles, and that concrete surfaces usually produce slightly louder tire noise than asphalt surfaces. There are, however, significant differences between newly poured, brushed surfaces and well-polished concrete. Interestingly, a tradeoff is that concrete surfaces tend to be slightly improved for fuel efficiency (tire rolling resistance) versus asphalt, although this difference is also influenced by the pavement underlayment.

Some current industry priorities may affect future tire noises. For example, tread depths for drive and steer axle tires may be reduced in an effort to improve fuel economy. Also, patterns that have more closed shoulders versus lugs, discontinuous blocks, especially on drive tires and simpler groove designs with increased siping, are all likely to become more popular in the quest to lower rolling resistance.

So, from a maintenance standpoint, what can be done to keep trucks as quiet as possible? Three things come to mind: First, spec the axle specific tires best suited for service conditions. Consult with tire manufacturer reps to validate selections, especially since many new tire models are currently becoming available.

Second, maintain inflation, alignment, tire/wheel assembly balance and wearing suspension components. Recent Type II testing shows a fuel economy advantage for trucks with all wheel positions balanced versus no balance. Therefore, balancing all wheel positions, even absent any vibration issues, may have a good payback for fuel saved, reduced irregular wear, extended take-off mileages and lower noise levels.

Third, make certain that your retread program uses only tread designs that minimize noise. This is becoming easier since many tire manufacturers are now in the retread business and new tire designs are typically followed shortly by tread patterns and compounds that duplicate original tread performance.

You May Also Like

Class 8 orders strong in February

Even when seasonally adjusted, ACT says preliminary order numbers for February are up 5% over January.

ACT-Class-8-Feb-truck-orders

According to the latest numbers from ACT Research, preliminary North America Class 8 net orders were 27,700 units, up 600 units from January and 16% from a year ago. With the fourth-largest seasonal factor of the year at 8%, seasonal adjustment reduces February’s Class 8 intake to 25,600 units, up 5% from January.

“Weak freight and carrier profitability fundamentals, and large carriers guiding to lower capex in 2024, would imply pressure in U.S. tractor, the North American Class 8 market’s largest segment,” said Kenny Vieth, ACT’s president and senior analyst. “While we do not yet have the underlying detail for February order volumes, Class 8 demand continuing at high levels again this month suggests that U.S. buyers continue as strong market participants.”

Beyond standard TPMS: The crucial role of customizable tire health alerts

Delving into the shortcomings of standard TPMS and why customizable tire health alerts are crucial for commercial vehicle fleets.

Driving for Alabama: A family affair

The stories of two truck drivers for ’80s country hitmakers Alabama.

Photos by Amazing Grace Photography
So you want to write for Fleet Equipment?

Of course you do. As the premiere online publication for the heavy-duty truck market, charting the latest in trucking equipment, technology, and service trends, Fleet Equipment has a knack for digging up the stories behind the stories (while having a lot of fun along the way). Now you can be a part of it! But

Write for Fleet Equipment
Babcox Media mourns the passing of Tim Fritz, longtime editor and friend

Babcox Media Editor Tim Fritz passed away on Feb. 23 from a heart attack. He was 53 years old. Related Articles – Debating the merits of ethanol – Why isn’t a truck’s appearance part of the PM process? – Change is coming to U.S. energy policies Tim joined Babcox Media in 1990 and spent 31

Tim-Fritz-1400x700

Other Posts

Goodyear unveils two RangeMax tires deisgned for regional work

Goodyear says the new tire models balance traction, range and mileage for work vehicles running on electricity, gas or diesel.

Goodyear-rangemax tires-group-logo
Kenworth delivers 15-liter natural gas-powered truck to UPS

The truck is equipped with the Cummins X15N, which Kenworth says will meet CARB and EPA Requirements for both 2024 and 2027.

Kenworth-delivers-CNG-truck-to-UPS
ACT Research: 2024 could see trucking recovery

Despite trucking demand remaining weak, ACT Research says imports and international data indicate positive trends in 2024.

ACT-for-hire-index-Jan-24
Navistar progressing toward autonomous hub-to-hub transport

Autonomous truck testing is underway, and the company expects customer pilots to be delivered later this year.

Navistar-Autonomous-partnership-Plus-international-truck