TruckCam highlights its Camera Wheel Alignment System, which is designed for measuring all wheel angles, including parallelism between axles, on commercial vehicles. It enables dynamic toe and camber measurements while in driving position, by using the unique TruckCam Rolling Method. For this measurement no lifting of the axles with run-out compensation is required. It also uses wireless technology for transmitting data between the measurement units and the computer. The computer program guides the user through the measuring process and prints out measuring reports of values measured before and after alignment.

According to TruckCam, the all-in-one software includes measurement features like:

• Wheel alignment system for commercial vehicles from 3.5 tons and above: The new wheel alignment software enables the operator to measure vehicles based on the center line principle as well as the thrust line principle.
• Frame check: The frame check software provides measurements of frames and chassis without any additional hardware. Frame deformations like side sway, vertical bend and torsion can be measured electronically in the shortest time possible.
• Twin rolling:By rolling the vehicle forward only once, the twin rolling software measures two axles at the same time in a matter of minutes.
• Preconfigured vehicles: This feature simplifies the selection of vehicle type, while also allowing the operator to create own vehicle types of up to 10 axles.
• Active graphical appearance of wheels and axles: The print-out report sheet as well as the measurement window graphically shows the actual position of axles and wheels before and after adjustment.