Ken-Tool Archives - Fleet Equipment Magazine
Ken-Tool releases Pilot Sleeve wheel centering sleeves for commercial trucks

Ken-Tool has released Pilot Sleeve wheel centering sleeves, manufactured to be used with steel or aluminum commercial truck steer wheels, drive wheels and inside/outside dual wheels that use two-piece flange nuts.

Ken-Tool announces tire valve installation tool

Ken-Tool has introduced a new tire valve installation tool to aid tire service technicians with the installation of “snap-in” rubber tire valve stems into automotive, light truck and trailer wheels. Made in the U.S.A., the new tire valve installation tool (pictured above) is made from cadmium plated, high carbon steel to insure a long service life. The handle

Ken-Tool introduces new truck axle retainer bolt sockets

Ken-Tool has announced the introduction of a series of sockets designed for removal and installation of axle nuts for the most common truck axle retainer nuts in today’s market. The axle nut sockets (pictured above) are made in the U.S.A. and cold pressed from high quality, tool-grade steel, assuring a long service life, and each socket

Ken-Tool introduces the T38B Metric Valve Breaker 35938

Ken-Tool released its T38B Metric Valve Breaker designed to remove valve stems from smaller 10mm valve stem holes which are common on heavy-duty aluminum and alloy wheels. The patented Metric Valve Breaker features a heat-treated steel punch. The punch is 9mm in diameter which allows it to remove nickel plated, steel and brass valve stems

Ken-Tool introduces axle drain pan

The 30600 Professional Super Single Axle Drain Pan from Ken-Tool can be securely attached to wheels using two or three lug studs with finger tightened nuts. The pan, which is contoured to rest flat with the sides gripping the wheel’s drop-center, fits most 22.5- and 24.5-in., 10-hole hub or stud-piloted steel or alloy wide-base and dual wheels. Made